• Ultra-Thin Film Thickness
• High Bond Strength and Durability
• Sustained Fluoride Release
• Excellent Biocompatibility
• Radiopacity for Easy Diagnosis
• Flexible and Waste-Reducing Dispensing
• Quick and Bubble-Free Mixing
• Reliable Clinical Performance

1) Gc Fujicem Refill Pack 13.3g Cartridge:

• 1 Cartridge (13.3 gm / 7.2 ml)
• Instruction Manual
• Mixing Pad

2) Gc Fujicem Luting Glass Ionomer - Dispenser:

• 1 x Dispenser only

1.         Material Type: Resin-reinforced glass ionomer luting cement
2.         Formulation: Paste-paste (Paste Pak System)
3.         Film Thickness: ~3 µm (microns)
4.         Mixing Time: ~10 seconds
5.         Working Time: Sufficient for precise placement
6.         Setting Time: Optimized for clinical efficiency
7.         Fluoride Release: Yes, sustained release
8.         Radiopacity: Yes
9.         Biocompatibility: Clinically safe and tissue-friendly

1.     Preparation:

• Clean and prepare the restoration and tooth surface according to standard cementation protocols.
• Ensure the surfaces are clean, dry, and free of debris or contaminants.

2.     Dispensing:

• Load the GC FujiCEM Paste Pak cartridge into the dispenser.
• Dispense equal amounts of both pastes directly onto a mixing pad.

3.     Mixing:

• Mix thoroughly for approximately 10 seconds until a uniform consistency is achieved.
• Avoid incorporating air bubbles during mixing.

4.     Application:

• Apply the mixed cement directly into the restoration (e.g., crown, bridge, inlay/onlay).
• Seat the restoration onto the tooth using firm, even pressure.

5.     Setting:

• Hold the restoration in position until the initial set.
• Follow the manufacturer’s recommended setting time (typically around a few minutes; refer to the product insert).

6.     Finishing:

• After the cement has set, remove excess material using a scaler or explorer.
• Finalize the margins and occlusion as needed.